DIRECTION FOR USE
Pour the Stencil removal liquid into a Polyethylene stripping tank or spray liquid on both side of screens. The screen is immersed in the stencil removal liquid. After 3-5 minutes the engraving lacquer will become loose. This time will depend on the temperature, at which polymerization was realized and number of times screen in used. We advise that the correct stripping time is established empirically.
After the screen has been taken from the Stencil removal liquid, any lacquer remaining is sprayed off with water and then the screen is very thoroughly rinsed with water and dried. The effect of the Stencil removal liquid will slowly decrease.
SAFETY
As Stencil removal liquid contains solvents and other volatile organic substance there should be provision for proper ventilation in the working space and the stripping tank should be covered. Stencil removal liquid should never be allowed to come into contact with skin. When working with the Stencil removal liquid it is compulsory to wear safety goggles, protective mask and gloves, protective clothing and safety shoes. The most suitable material for gloves and clothing is polythene. Immediately after it has come into contact with Stencil removal liquid the material must be washed off. When the skin has been affected, rinsed-off with lot of water, dry it thoroughly and then treat with fatty cream.
After rinsing out with the aid of any eye-bath and a strongly diluted solution of sodium bicarbonate, on doctor 's prescription, the eyes shall be washed, after which a few drops of castor oil applied into the eye; immediately afterward consult eye surgeon or other doctor. The above must be available in the working area.
After the screen has been taken from the Stencil removal liquid, any lacquer remaining is sprayed off with water and then the screen is very thoroughly rinsed with water and dried. The effect of the Stencil removal liquid will slowly decrease.
SAFETY
As Stencil removal liquid contains solvents and other volatile organic substance there should be provision for proper ventilation in the working space and the stripping tank should be covered. Stencil removal liquid should never be allowed to come into contact with skin. When working with the Stencil removal liquid it is compulsory to wear safety goggles, protective mask and gloves, protective clothing and safety shoes. The most suitable material for gloves and clothing is polythene. Immediately after it has come into contact with Stencil removal liquid the material must be washed off. When the skin has been affected, rinsed-off with lot of water, dry it thoroughly and then treat with fatty cream.
After rinsing out with the aid of any eye-bath and a strongly diluted solution of sodium bicarbonate, on doctor 's prescription, the eyes shall be washed, after which a few drops of castor oil applied into the eye; immediately afterward consult eye surgeon or other doctor. The above must be available in the working area.
Comments
Post a Comment